JL-250G Rotate Photocontrol Receptacle fit to NEMA 7 PIN Surge Protection Module

Product Description

The JL-250GXA rotary locking photocontroller socket is designed for outdoor fixtures to accept rotary locking photo controllers for control of LED fixtures. It provides four gold-plated curved contact tabs on the top surface to fit the spring contacts (ANSIC13641) of the rotary-locking photocontroller, and four signal wires on the back. In particular, the ground terminal in the center of the receptacle provides common mode surge protection with the JL-250F**C* series. This product meets the requirements of ANSIC136.10, ANSIC136.41 and ANSI/UL773 standards for plug-in twist-lock photocontrollers for use in area lighting.

Features
1-Body made of polybutylene terephthalate (PBT) Contacts made of phosphor bronze.
2-Center ground terminal, here should fit to JL-250F**C* series to achieve common mode surge protection.
3- Can be loosened after the screw to find the north, to facilitate the installation of the light controller (installation of the default pointing to the north) to avoid the decline of the light controller photosensitive components to extend the service life.
4-Provide waterproof silicone gasket.

5-Certificate: ANSI C136.41, UL, CB ,CE etc

Product Parameter

Product   Model	JL-250G
Applicable Volt Range	0~480VAC
Rated   Frequency	50/60Hz
Power Loading	AWG#14: 15Amp max. / AWG#16: 10Amp m
Optional   Signal Loading	30VDC,   1500mA Max
Ambient Temperature	-40℃ ~ +70℃
Rear   Cover	option
Leads	6″ Min. (See Ordering   Information)

Product size

Wiring Diagram