How can we help you?
Product Introduction
JL-205C twist-lock analog electronic light control switch series products are applicable to the independent control of street lighting, garden lighting, passage lighting, porch lighting and park lighting according to the natural lighting level of the environment.
This series of products adopt an electronic design with photosensitive tubes and are equipped with surge arresters (MOV). In particular, JL-205C can meet all kinds of power supply and provide customers with a wider range of voltage.
In addition, its delay control function can avoid redundant operation caused by spotlights or lightning at night.
This series of products provide three lock terminals, which meet the requirements of ANSI C136.10 and ANSI/UL773 area lighting plug-in and twist-lock photocontrol.
Three-view
Product Features
*ANSI C136.10 Rotary lock
*Delay 3-20 seconds
*Built in surge protection
*Failure mode: light on
*UV resistant housing
Parameter List
Installation Instructions
*Disconnect the power supply.
*Connect the socket according to the figure below.
*Push the photoelectric controller up and turn it clockwise to lock it in the socket.
*If necessary, adjust the socket position to ensure that the light sensing port points to the north as shown in the triangle at the top of the light controller.
Initial Testing
*The Photocontrol turns off immediately when initially installed.
*To test “turn on” during daytime, cover its eye with opaque material.
*Do not cover with finger because light traveling through fingers may be great enough to keep the Photocontrol off.
*photocontrol test will take approximately 2 minutes.
* Operation of this Photocontrol is not affected by weather, moisture or temperature changes.
Product Code Table
1: 12 = MOV 110Joule / 3500Amp
15 = MOV 235Joule / 5000Amp
23 = MOV 460Joule / 7500Amp
Empty=no MOV
2: C=PC housing
P=PP shell
K=PP inner shell+PC outer shell
3: D=Green
F=Blue
Customizable
4: IP65=elastomer ring+silicone outer seal
IP54=electronic associated foam washer