Die-cast Aluminum JL-126a Wire Controller 120V

Description

The photocontrol JL-126 is applicable to control the passage lighting and doorway lighting automatically auto turn on/ turn off by the ambient lighting level.

Feature

1-Additional Swivel Available

2-Screw Thread （NPT 1/2"）& Zinc Alloy Nut

3-Aluminum Die-cast Enclosure

4-Road Loading:3000VA'

Product Parameters

item	JL-126A	JL-126B	JL-126D
Roading   Voltage	120VAC	220-240VAC	277VAC
Road   Frequency	50/60Hz
Road Loading	3000W Tungsten,2000VA   Ballast		3000W   Tungsten,3000VA Ballast
Power   Consumption	1.5W Max
Fail Mode	Fain on
certificate	UL,CE,RoHS

Install Instructions

Disconnect the power supply, remove the junction box cover, put the waterproof rubber ring on the threaded pipe of the light-operated switch, pass it through the through hole from the inside to the outside, and tighten it with a copper alloy locking nut from the outside.

If necessary, slide the shading strip to give it the preferred on/off level.

When installing the lamp, do not let the photosensitive eye face the direction of the artificial light source or its reflected light, otherwise, it may cause the lamp to cycle on and off at night.

Wiring Diagram

start operation

.When the light switch is powered on for the first time, it will light up and wait for about a minute before turning off the light. This is normal.

·When testing the light during the day, cover its photosensitive eye with black tape or other opaque material.

·Do not cover the photosensitive eye with your fingers, because the light passing through the gap between your fingers may be enough to keep the light switch off.

·The test time is about 2 minutes.

Product Code

1: A=120VAC

B=220~240VA

D=277VAC

2: Lead Rating

16=16 AWG, 150ºC rated

Customizable, 4"min

4: V(option) =swivel added

5: CA20(option) = California Title 20

Assemblies