How can we help you?
How can we help you?
The Dusk till Dawn Sensor for led outsides lights JL-118 series is applicable to control the street lighting, passage lighting and doorway lighting automatically in accordance with the ambient lighting level.
This dusk till dawn sensor is designed on the basis of electrical heating structure that provides time delay over 30 seconds to avoid redundant switching against spotlight or lightning during the night time. A temperature compensator system provides consistent performance regardless of the ambient temperature.
JL-118 series dusk till dawn sensor is convenient direction adjustment after installation once an additional swivel is applied.
Dusk till Dawn Sensor Addvantages:
Dusk till Dawn Sensor Features:
JL-118 Dusk till Dawn Sensor Diagram:
Model No. | JL-118A | JL-118B |
| Rated Voltage | 100-120VAC | 200-240VAC |
Rated Frequency | 50/60Hz | |
| Rated Loading | 1000W Tungsten, 1800VA Ballast | |
Power Consumption | 1.5VA | |
| On/Off Level | 10-20 Lx On;30-60 Lx Off | |
Ambient Temp. | -40℃ to +70℃ | |
Related Humidity | 95% | |
Body Mean | 41(wide)x32(depth)x72(height)mm | |
Swivel Meas | 65(L)x35(Dia.Max)mm;180° | |
Weight Approx. | 55 grs(Body),20 grs(Swivel) | |
Time of warranty | Each one uses up to 5000 times,3 Years Warranty! | |
FAQ About JL-118 Dusk till Dawn Sensor
Q1:How long is this Dusk till Dawn Sensor?
A1:The Dusk till Dawn Sensor’s Body Mean 41 (wide)x32(depth)x72(height)mm,Swivel Means 65(L)x35(Dia.Max)mm.
Q2:Will this work powering a low wattage (18- 36 W )florescent bulb?
A2:This Dusk till Dawn Sensor can achieve .As long as your voltage is between 120-277volts.
Q3:The JL-118 Dusk till Dawn Sensor Wiring Instructions?
A3:FIRST MAKE SURE POWER IS SHUT OFF TO CIRCUIT. Make sure you follow the instructions and connect proper color wires to each other. It is possible to connect multiple lights to this one unit with wire nuts. Make sure connection are protected from the elements.
Q4:Can the JL-118 Dusk till Dawn Sensor control multiple lamps?
A4：In general, it is recommended that each Dusk till Dawn Sensor only control one lamp, but if it can be used within the load range of the Dusk till Dawn Sensor, you can try. But the final use effect depends on the actual situation of the customer.
Disconnect power, remove junction box cover, place the dusk till dawn sensor in knockout hole and fasten with locknut.
Wire according to the diagram in right hand.
Do not install the dusk till dawn sensor with the Photocell facing artificial or reflected light. This will cause the unit to cycle on and off at night.
Before installing the dusk till dawn sensor, you must keep the power off to ensure safety.Then follow the wiring instructions of the dusk till dawn sensor to install.
Copyright Longjoin Electronics Co., Ltd. Shanghai 2008. All Rights Reserved
沪ICP备2022000883号-1
